Trane Modular 20 to 35 Tons Instrukcja Instalacji Strona 3

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 2
Warnings, Cautions and Notices
CXRC-SVX01F-EN 3
Introduction
About This Manual
Note: One copy of this document ships inside the control
panel of each unit and is customer property. It must
be retained by the unit's maintenance personnel.
This booklet describes proper installation, operation, and
maintenance procedures for air cooled systems. By
carefully reviewing the information within this manual
and following the instructions, risk of improper operation
and/or component damage will be minimized. It is
important that periodic maintenance be performed to help
assure trouble free operation. A maintenance schedule is
provided at the end of this manual. Should equipment
failure occur, contact a qualified service organization with
qualified, experienced HVAC technicians to properly
diagnose and repair this equipment.
R-410A Refrigerant
System is designed to be compatible with R-410A
refrigerant.
Refer to previous IOM versions for R-407C and R-22 units,
or contact your localTrane representative.
Refer to the appropriate IOM for air-cooled condenser
CXRC-SVX01 and programming Intellipak controls PKG-
SVP01.
Air Cooled Condenser units are applied with SCRF/SIRF or
SCRG/SIRG Commercial Self Contained units with
IntelliPak controls or thermostat interface.
Cross References to related publications/
information
IntelliPak® Self-Contained Programming Guide, PKG-
SVP01*-EN
Commercial Self-Contained IntelliPak Signature Series
Installation, Owner, and Diagnostic Manual, SCXF-
SVX01*-EN
Commercial Self-Contained IntelliPak Modular Series
Installation, Owner, and Diagnostic Manual, SCXG-
SVX01*-EN
TheTrane Reciprocating Refrigeration Manual
Revision Summary
CXRC-SVX01F-EN (13 Feb 2013)
Remove wiring diagrams. Add wiring diagram numbers
and reference to e-library. Update operating principals to
remove obsolete reference designators.
CXRC-SVX01E-EN (23 Oct 2012)
Updated fan motor information.
Trademarks
Trane, Intellipak,Trane 3-D and theTrane logo are
trademarks ofTrane in the United States and other
countries. All trademarks referenced in this document are
the trademarks of their respective owners.
NOTICE:
Use Copper Conductors Only!
Unit terminals are not designed to accept other types
of conductors. Failure to use copper conductors could
result in equipment damage.
Przeglądanie stron 2
1 2 3 4 5 6 7 8 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag